1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Z Axis Ribbing Issues

Discussion in 'Troubleshooting' started by Montravont, May 12, 2014.

Thread Status:
Not open for further replies.
Page 3 of 3
  1. Marcus T

    Marcus T Member

    Joined:
    Aug 14, 2014
    Messages:
    39
    Likes Received:
    6
    Just got done printing. I printed the 20mm cube. (Printed with PLA)
    X and Y measurements are over by a hair (just like they always have been).
    Z measures in at 19.88mm. Which is a huge improvement compared to the 17.5mm when I started.

    I guess I'll just have to make minor calibration adjustments from here to get it perfect.
     
    #41 Marcus T, Aug 22, 2014
    2 people like this.
  2. Ziggy

    Ziggy Moderator
    Staff Member

    Joined:
    Feb 20, 2013
    Messages:
    707
    Likes Received:
    530
    Suggest you measure your rods as well. At some point the Robo guys were planning to move to 8mm rods.
     
    #42 Ziggy, Aug 22, 2014
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    .12mm might be due to a non-idea first layer or measurement error.

    They're still on 5/16" everything unfortunately.

    Be sure you also measure your filament diameter.
     
    #43 Mike Kelly, Aug 27, 2014
  4. RokleM

    RokleM Member

    Joined:
    Jul 20, 2014
    Messages:
    60
    Likes Received:
    16
    #44 RokleM, Aug 27, 2014
  5. cnr141

    cnr141 Member

    Joined:
    Aug 6, 2014
    Messages:
    46
    Likes Received:
    0
    if you use MC , just change the perimeter settings.. Make it "1" even you print 0,2 layer things really change, the finish surfaces look almost perfect.
    worth to try
     
    #45 cnr141, Aug 31, 2014
Page 3 of 3
Thread Status:
Not open for further replies.

Share This Page