1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer Z Height Issue

Discussion in 'Troubleshooting' started by CCJ, Feb 25, 2017.

  1. CCJ

    CCJ New Member

    Joined:
    Feb 23, 2016
    Messages:
    9
    Likes Received:
    1
    I have a Robo3d R1+ and the Z calibration doesn't seem to be working properly. At the front end of the plate the print seems to be almost perfect, but as it progresses to the rear the print head goes up and up to where visually it looks like the print head is almost 1/8" higher. Has anyone seen or fixed this issue?
     
    #1 CCJ, Feb 25, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Manually leveling the bed is the easiest approach.
    Make sure the X axis is close to level and the entire autoleveling works much better.
     
    #2 mark tomlinson, Feb 25, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #3 mark tomlinson, Feb 25, 2017

Share This Page