Recent Content by Boys & Girls Club

Post

Your signature shows "Staff Member" so I was assuming that you are employed by Robo.

Post by: Boys & Girls Club, May 31, 2018 in forum: Troubleshooting

Post

How can you get me there on a forum when sending the machines back to you (Robo) did nothing?

Post by: Boys & Girls Club, May 31, 2018 in forum: Troubleshooting

Post

I would hope that they did this when I sent the machine back to them. At this point I only know how to print the pre-configured jobs that are on...

Post by: Boys & Girls Club, May 31, 2018 in forum: Troubleshooting

Post

We sent the printer back. They never mentioned that we should use different filament. We have tried multiple spools. Large spools, small...

Post by: Boys & Girls Club, May 31, 2018 in forum: Troubleshooting

Post

Are you experiencing the below picture? Good luck with Robo support. We have been having the same issues for months and they are still...

Post by: Boys & Girls Club, May 31, 2018 in forum: Troubleshooting

Thread

Here is the key problem: We have 2 carts (which we purchased from Robo 3D) that the printers sit on where the PLA spools can be hung from above...

Thread by: Boys & Girls Club, May 31, 2018, 12 replies, in forum: Troubleshooting