Separate names with a comma.
Okay! Thanks for clearing things up
It doesn't matter which ones go where as far as the heater goes does it because it is a semiconductor?
Mine does the exact same thing. Don't know exactly what the problem is tho.
Here are where the connections of the old heated bed are on my ramps
And here are what the connections to the new one looks like
Yeah my wiring is different. My wires are held in with screws to the ramps board. But I will send a picture
I recently had to order a new heated bed after cracking mine trying to get a print off. The problem is the bed that I ordered has completely...
Just ordered 2 of them just to be safe. When they come in ill do a follow up on if it helps or not.
Which do you recommend? Or are they both the same
Okay I have just noticed something before I started printing. I heated up the hot end and started manually turning the Hobbed bolt gear with my...
Okay I will try that and print again and come back with results
Here's the Hobbed bolt
Yes that's exactly what it does. The gear moves but the filament hesitates to go through for a second.
Yes I have even taken some extra steps to make it as tight as possible