1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by charlie13

  1. charlie13
    Post

    Unanswered Is this an outline overlap issue?

    Examples
    Post by: charlie13, May 16, 2016 in forum: Troubleshooting
  2. charlie13
    Thread

    Unanswered Is this an outline overlap issue?

    It appears that my prints infills are not making enough contact with the borders. I'm using Simplified 3D and believe this can be fixed by...
    Thread by: charlie13, May 16, 2016, 3 replies, in forum: Troubleshooting
  3. charlie13
    Post

    Unanswered NOOB questions on first layers/leveling

    Photo for reference
    Post by: charlie13, May 15, 2016 in forum: Troubleshooting
  4. charlie13
    Thread

    Unanswered NOOB questions on first layers/leveling

    So I'm working on calibrating and adjusting my bed/z axis/z-offset.I noticed that the filament gets swished down (head being too low from what...
    Thread by: charlie13, May 15, 2016, 4 replies, in forum: Troubleshooting
  5. charlie13
    Post

    Solved Bed noise and filament not extruding on certain parts of bed

    Mark, Thanks for the response. I rechecked under the bed and observed some plastic in the center belt (the one that controls the movement of...
    Post by: charlie13, May 14, 2016 in forum: Troubleshooting
  6. charlie13
    Thread

    Solved Bed noise and filament not extruding on certain parts of bed

    Hi All! I'm new to the forum and decided after 6-7 hours of searching to ask directly some questions to the members. I have a Robo 3D R1 Plus. I...
    Thread by: charlie13, May 14, 2016, 3 replies, in forum: Troubleshooting