1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by dairdevil

  1. dairdevil
    Post

    Z Axis Wizard Problems

    Thanks Mark… Turns out it was a software issue. Once I reflashed the micro SD with good software it worked out perfectly! Thanks for your time.
    Post by: dairdevil, Dec 16, 2019 in forum: Troubleshooting
  2. dairdevil
    Post

    Z Axis Wizard Problems

    Plus… Should I be seeing a red dot on my bed if the IR sensor is working? I currently don’t see anything.
    Post by: dairdevil, Dec 16, 2019 in forum: Troubleshooting
  3. dairdevil
    Post

    Z Axis Wizard Problems

    Do you think I should try to reset my home offset to 0?
    Post by: dairdevil, Dec 16, 2019 in forum: Troubleshooting
  4. dairdevil
    Post

    Z Axis Wizard Problems

    Thanks Mark... I went in and checked my settings. The home setting offset was -20. The bed offset setting was 0. I am wondering if I have a bad...
    Post by: dairdevil, Dec 16, 2019 in forum: Troubleshooting
  5. dairdevil
    Post

    Z Axis Wizard Problems

    My apologies! It is in R2...
    Post by: dairdevil, Dec 16, 2019 in forum: Troubleshooting
  6. dairdevil
    Thread

    Z Axis Wizard Problems

    Hello... just got a lightly used machine. Everything seems to be working fine (Wi-Fi connectivity, hot ends, stepper motors). But I’ve run into...
    Thread by: dairdevil, Dec 16, 2019, 17 replies, in forum: Troubleshooting