1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by David Avila

  1. David Avila
    Post

    Answered R1 + 40W Ceramic Cartridge Heater issue

    I returned them and order from new ones from a different seller. So ill keep you up to date. Thanks for all the help
    Post by: David Avila, Aug 30, 2018 in forum: Troubleshooting
  2. David Avila
    Post

    Answered R1 + 40W Ceramic Cartridge Heater issue

    ok I was thinking they are bad also, I will try one more and see. I just worried about the wires getting hot like that
    Post by: David Avila, Aug 28, 2018 in forum: Troubleshooting
  3. David Avila
    Thread

    Answered R1 + 40W Ceramic Cartridge Heater issue

    Hello my cartridge heater went out so I got some from Amazon....
    Thread by: David Avila, Aug 28, 2018, 5 replies, in forum: Troubleshooting
  4. David Avila
    Post

    Partial Answer lines on prints

    Ok I don Ok I dont know how to adjust the number for the calibration. My average for 100mm was 89.99 so I'm under extrusion. How do I adjust the...
    Post by: David Avila, Mar 6, 2018 in forum: Troubleshooting
  5. David Avila
    Post

    Partial Answer lines on prints

    tried the oiler and different file same issue, I want to calibrate but dont know how to change the settings, I use matter control with a xxl lcd
    Post by: David Avila, Mar 5, 2018 in forum: Troubleshooting
  6. David Avila
    Thread

    Unresolved Lines on print

    I'm not getting smooth prints I'm getting lines please check the picture, thanks. [ATTACH]
    Thread by: David Avila, Mar 3, 2018, 2 replies, in forum: Troubleshooting
  7. David Avila
    Post

    Solved Broken Glass

    Thanks how about PEI will that work better?
    Post by: David Avila, Feb 23, 2018 in forum: Troubleshooting
  8. David Avila
    Thread

    Solved Broken Glass

    I got chip about a quoter size in the middle would a a build surface like the link work to go over the glass? Thanks...
    Thread by: David Avila, Feb 23, 2018, 3 replies, in forum: Troubleshooting
  9. David Avila
    Thread

    Partial Answer lines on prints

    I have a robo 1 and robo 1 plus and I'm getting lines on both printers on only this print I have same print but wider and no lines setting are...
    Thread by: David Avila, Feb 22, 2018, 7 replies, in forum: Troubleshooting
  10. David Avila
    Post

    greg wade extruder reloaded bolts

    ok thanks there M4 55m
    Post by: David Avila, Feb 8, 2018 in forum: Mods and Upgrades
  11. David Avila
    Thread

    greg wade extruder reloaded bolts

    Any links and size for the screws on the stock or modded greg wade extruder reloaded? Thanks [ATTACH] [ATTACH]
    Thread by: David Avila, Feb 8, 2018, 4 replies, in forum: Mods and Upgrades