1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by eisman

  1. eisman
    Thread

    R1 non-plus Marlin 2.0.x Bugfix UBL

    Got Marlin 2 working on my R1, and trying to use UBL. After I clear EEPROM and do G29 P1 my mesh looks like this: Recv: Bed Topography Report:...
    Thread by: eisman, Jan 27, 2019, 1 replies, in forum: Projects
  2. eisman
    Post

    Community Favorite Marlin 2.0.x release for Robo R1+

    I have the motors working again. I had to comment out two lines in Configuration_adv.h #define Z_STEPPER_AUTO_ALIGN #define Z_DUAL_STEPPER_DRIVERS
    Post by: eisman, Jan 26, 2019 in forum: Mods and Upgrades
  3. eisman
    Post

    Community Favorite Marlin 2.0.x release for Robo R1+

    Thank You. It seems that there is nothing wrong with the steppers, nor driver. I can home and print with 1.1.7 (1.1.1 Mesh) I cannot home...
    Post by: eisman, Jan 26, 2019 in forum: Mods and Upgrades
  4. eisman
    Post

    Community Favorite Marlin 2.0.x release for Robo R1+

    So I don't have to worry about the R1 having both Z steppers on one driver where R1+ uses the E1 stepper? The reason I ask is that I have...
    Post by: eisman, Jan 26, 2019 in forum: Mods and Upgrades
  5. eisman
    Post

    Community Favorite Marlin 2.0.x release for Robo R1+

    Before I go attempt this, is it possible to make this work with the R1 non-plus?
    Post by: eisman, Jan 26, 2019 in forum: Mods and Upgrades