Recent Content by Iggy

Post

I've turned ACK on to monitor the communication, and when I send a command, the corresponding G-code is recorded, and I'm receiving an "ok" back...

Post by: Iggy, Jun 25, 2016 in forum: Troubleshooting

Post

Thanks for the help. Gave it a try, to no avail. I'll keep searching.

Post by: Iggy, Jun 24, 2016 in forum: Troubleshooting

Thread

Sorry if this is a duplicate request, but I couldn't find anything via search... My Robo printer (one of the original versions from Kickstarter)...

Thread by: Iggy, Jun 24, 2016, 5 replies, in forum: Troubleshooting

Thread

Hi Everyone... My printer seems to be doing quite well these days. My only challenge has to do with objects coming loose from the bed. I...

Thread by: Iggy, Nov 20, 2013, 6 replies, in forum: Troubleshooting

Thread

Hi all... Things were going well, with nearly a 100% success rate on printing with the new PLA ROBO 3D. Then, things started warping on me. I...

Thread by: Iggy, Sep 12, 2013, 15 replies, in forum: Troubleshooting