Recent Content by Jason Bates

Post

Yeah neither of them work Sent from my SM-G955U using Tapatalk

Post by: Jason Bates, Feb 22, 2018 in forum: Mods and Upgrades

Post

I am trying to do this upgrade on my R1+ and have became stuck :( I installed the new ramps 1.4 board, and installed the new driver. The chimera...

Post by: Jason Bates, Feb 22, 2018 in forum: Mods and Upgrades

Post

attached is my config.h

Post by: Jason Bates, Feb 7, 2018 in forum: Mods and Upgrades

Post

Sorry I'll post my config.h file when I get off work. I know is switched motherboard to 34 and changed extruders to 2. Sent from my SM-G955U...

Post by: Jason Bates, Feb 7, 2018 in forum: Mods and Upgrades

Thread

So I have the wiring with the new ramps 1.4 board. The 5 drivers. The hotends and bed heat up correctly. The 2 extruders I mounted on the side of...

Thread by: Jason Bates, Feb 6, 2018, 4 replies, in forum: Mods and Upgrades

Thread

Well my hot end fan stopped working on me while he of course caused a major clog. I have put in an order for a replacement fan but they are not in...

Thread by: Jason Bates, Feb 20, 2017, 1 replies, in forum: Troubleshooting

Thread

i have had my robo r1 plus for over a month now and it has been printing like a champ until tonight. I am printing with pla btw. The printer homes...

Thread by: Jason Bates, Feb 26, 2016, 10 replies, in forum: Troubleshooting