1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Johnh

  1. Johnh
    Post

    Unanswered Filament loads without problem but then won’t print

    Hi Thanks PLA filament. yes all is turning. I Cleaned The hobbled bolt. It Chews up filament. Tried raising nozzle also.
    Post by: Johnh, Jun 29, 2020 in forum: Troubleshooting
  2. Johnh
    Thread

    Unanswered Filament loads without problem but then won’t print

    I load filament with no problem. Runs through nicely. Go to print right after load and it won’t print, gear turns though. I can unload and...
    Thread by: Johnh, Jun 29, 2020, 5 replies, in forum: Troubleshooting
  3. Johnh
    Thread

    Solved Filament gets brittle during print and breaks below hobb

    Hi first time posting I have an Robo 3D r1 +. I have printed with it for about 3 years or a little more. The problem I am having is with PLA. I...
    Thread by: Johnh, Aug 14, 2019, 1 replies, in forum: Troubleshooting
  4. Johnh
    Post

    Molds for chocolate

    Thanks I'll look into makersgeek
    Post by: Johnh, Sep 25, 2016 in forum: Projects
  5. Johnh
    Post

    Molds for chocolate

    Thanks probably over time both methods. Would PLA WORK considering the low Temps required for chocolate and if I'm not mistaken it's organic...
    Post by: Johnh, Sep 8, 2016 in forum: Projects
  6. Johnh
    Thread

    Molds for chocolate

    Has anyone made any molds for choocolate?
    Thread by: Johnh, Sep 7, 2016, 10 replies, in forum: Projects