Separate names with a comma.
Thanks, i put bleu tape everywhere and all go right.
It si R2. when the hotend is center left position, it descends and sinks into the bed. the bed becomes deformed and the error appears....
For the past few days I have been unable to print. at the beginning of the printing, when the printer calibrates, the first point, the second, the...
Thanks a lot
Hello, Who know what are the latest versions of firmware, eeprom, robo os... and all what i have to update ? Could you tell how i have to proceed...
Thanks
Ok thank you
Hello, Does the R2 hotend is a standard one ? Can i fond it on Amazon ? Thank
Ok i will try
I solved the problem, i made a mistake in cura... now the print is very good. So this is my first good print with my R2! Thank[ATTACH]
Thank i will try, i will post the result
When i load the pla, it’s ok... i try to clean the nozzle... Could i try to increase the temperature to clean the nozzle ?
Post