1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by mindphunk

  1. mindphunk
    Post

    Solved How to reflash...

    Well, it worked... for about 30 seconds. My current problem is that the bed is not heating and Jonah at Partsbuilt said robo suggested a reflash....
    Post by: mindphunk, Dec 11, 2019 in forum: Troubleshooting
  2. mindphunk
    Post

    Solved How to reflash...

    I definitely have the r1+. I had downloaded the faq off of google some time ago, but even then it said it was outdated. Is there a particular...
    Post by: mindphunk, Dec 11, 2019 in forum: Troubleshooting
  3. mindphunk
    Post

    Solved How to reflash...

    Solved?
    Post by: mindphunk, Dec 11, 2019 in forum: Troubleshooting
  4. mindphunk
    Post

    SD Card

    I couldnt get it to work. Just couldnt get it to load.
    Post by: mindphunk, Dec 11, 2019 in forum: General Questions
  5. mindphunk
    Thread

    Solved How to reflash...

    Ive been advised to reflash my r1+ due to all the problems ive been having. Having never reflashed anything but a 2012 honda grom, is there a step...
    Thread by: mindphunk, Dec 11, 2019, 7 replies, in forum: Troubleshooting
  6. mindphunk
    Post

    SD Card

    So if I read that correctly, I just pop the card into the printer and it prints. Seems almost too easy.
    Post by: mindphunk, Dec 2, 2019 in forum: General Questions
  7. mindphunk
    Post

    SD Card

    I should just start all my posts with "hey Mark".
    Post by: mindphunk, Dec 2, 2019 in forum: General Questions
  8. mindphunk
    Thread

    SD Card

    I'm having issues with both my computer and my mattercontrol t10 tablet. Computer just pixelates and shuts down randomly lately and the tablet...
    Thread by: mindphunk, Dec 2, 2019, 8 replies, in forum: General Questions
  9. mindphunk
    Post

    Solved Now what?!

    Thanks for the hrlp. Ended up deleting all the COM ports and restarting the computer.
    Post by: mindphunk, Sep 2, 2019 in forum: Troubleshooting
  10. mindphunk
    Post

    Solved Now what?!

    A Device Attached To The System Is Not Operating.
    Post by: mindphunk, Aug 30, 2019 in forum: Troubleshooting
  11. mindphunk
    Thread

    Solved Now what?!

    Printed a beautiful piece that took nearly 30 hours. Started another print and now mattercontrol cannot find my printer or says its not operating....
    Thread by: mindphunk, Aug 30, 2019, 4 replies, in forum: Troubleshooting
  12. mindphunk
    Post

    Partial Answer Cooling Issue?

    Today, out of nowhere, my hot end is too hot at the wrong end I guess. Its producing small bulbs of filament before it reaches in the entrance of...
    Post by: mindphunk, Jul 30, 2019 in forum: Troubleshooting