1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Parker

  1. Parker
    Thread

    I need a R1+ v6 quick release spacer

    I recently broke my hexagon hotend, so i decided to get the e3d v6. I am unable to print the new quick release plate, because the v6 moves around...
    Thread by: Parker, Jan 7, 2018, 1 replies, in forum: General Questions
  2. Parker
    Post

    Partially Solved Bad prints on new e3d v6

    Would creating a z axis offset do the trick? What software do most people here use?
    Post by: Parker, Dec 28, 2017 in forum: Troubleshooting
  3. Parker
    Post

    Partially Solved Bad prints on new e3d v6

    How can I change the g-code startup script? I looked at the gcode terminal in mattercontrol but I have no clue what I'm looking at lol.
    Post by: Parker, Dec 28, 2017 in forum: Troubleshooting
  4. Parker
    Post

    Partially Solved Bad prints on new e3d v6

    How would I do that? I'm using mattercontrol if that means anything. Would I need to download a "temperature tower" and manually adjust the temps...
    Post by: Parker, Dec 28, 2017 in forum: Troubleshooting
  5. Parker
    Thread

    Partially Solved Bad prints on new e3d v6

    I recently upgraded from the hexagon to the e3d v6 on my R1+. After adjusting the firmware and trying to print the calibration box in PLA, it...
    Thread by: Parker, Dec 28, 2017, 6 replies, in forum: Troubleshooting
  6. Parker
    Thread

    Changing firmware r1+ mattercontrol?

    I installed the e3d v6 and I was told I need to change the firmware, but I have no clue how I would do so. Can anyone help me with this? Near...
    Thread by: Parker, Dec 26, 2017, 1 replies, in forum: General Questions
  7. Parker
    Thread

    Solved E3d v6 or another hexagon

    After cleaning the heat block of my original hexagon hotend, I may or may not have totally stripped the threads where the nozzle goes in the heat...
    Thread by: Parker, Dec 17, 2017, 2 replies, in forum: General Questions
  8. Parker
    Post

    Community Favorite Taking the R1+ ramps and rewiring to make generic Ramps Work

    I followed the instructions to the tee, except i wired in the leds and fan directly to the 12v power supply. When I run the mattercontrol 3d...
    Post by: Parker, Dec 15, 2017 in forum: Mods and Upgrades
  9. Parker
    Post

    Solved R1+ not turning on anymore.

    Last thing, if it is just the mega board that is bad, couldnt I just replace it and use the existing ramps board?
    Post by: Parker, Dec 13, 2017 in forum: Troubleshooting
  10. Parker
    Post

    Solved R1+ not turning on anymore.

    Thanks
    Post by: Parker, Dec 13, 2017 in forum: Troubleshooting
  11. Parker
    Post

    Solved R1+ not turning on anymore.

    This is totally off topic, and I should probably just post a new thread about this, but is it possible to print in ninjaflex on the r1+? I...
    Post by: Parker, Dec 13, 2017 in forum: Troubleshooting