1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Qaytin

  1. Qaytin
    Thread

    Answered Concave print

    I an trying to print a straight cylinder but it comes out concave.
    Thread by: Qaytin, Nov 22, 2018, 1 replies, in forum: Troubleshooting
  2. Qaytin
    Post

    Unresolved Bed Not Heating

    Thank you I will look into it and at lease it gives me a place to start.
    Post by: Qaytin, Aug 24, 2017 in forum: Troubleshooting
  3. Qaytin
    Thread

    Unresolved Bed Not Heating

    Printing bed not heating robo R1. Finished doing a print and I let it cool down before I removed the print and tried to start a second print but...
    Thread by: Qaytin, Aug 24, 2017, 4 replies, in forum: Troubleshooting
  4. Qaytin
    Post

    Solved Interrupted Print

    It solved it self
    Post by: Qaytin, Aug 24, 2017 in forum: Troubleshooting
  5. Qaytin
    Thread

    Solved Interrupted Print

    I printed 22 peaces on my 3D R that came out perfect and while I was printing the vary last peace (of course) when the printer stop right in the...
    Thread by: Qaytin, Aug 6, 2017, 2 replies, in forum: Troubleshooting
  6. Qaytin
    Post

    Connectors

    Perfect Thank you
    Post by: Qaytin, Nov 21, 2016 in forum: General Questions
  7. Qaytin
    Thread

    Connectors

    I am going to be upgrading my Robo 3Dr are soon to a double extruder and I have almost all the parts but I was wondering where I could get the...
    Thread by: Qaytin, Nov 20, 2016, 3 replies, in forum: General Questions
  8. Qaytin
    Post

    Solved Printer not printing first few layers or out line

    Thanks I will keep playing with it
    Post by: Qaytin, Aug 26, 2016 in forum: Troubleshooting
  9. Qaytin
    Post

    Solved Printer not printing first few layers or out line

    I set the Z offset to 1 mm then printed anther calibration box and I got the out line but the bottom of the was not solid. Changed the Z offset .5...
    Post by: Qaytin, Aug 25, 2016 in forum: Troubleshooting
  10. Qaytin
    Post

    Solved Printer not printing first few layers or out line

    Thanks for getting back to me so fast. Yes I am using Matter control and the bottom is solid but on one of the boxes you can see the infill. All...
    Post by: Qaytin, Aug 25, 2016 in forum: Troubleshooting
  11. Qaytin
    Thread

    Solved Printer not printing first few layers or out line

    I recently installed a new hot end of my 3D R1 plus and everything seems fine except that it doesn’t print the outline nor the first few layers of...
    Thread by: Qaytin, Aug 25, 2016, 9 replies, in forum: Troubleshooting