Recent Content by Sam Ho

Post

The plastic hold the belt broke. Screw and nut to hold the plastic at the front side of the head bed lost, which is the one you can see at the...

Post by: Sam Ho, Jul 17, 2016 in forum: Troubleshooting

Post

Thanks for your suggestion to contact technical support, will try. To print a new one is good, I can ask my friend to help, but one screw and nut...

Post by: Sam Ho, Jul 17, 2016 in forum: Troubleshooting

Post

Oh, the bell is good, but the plastic end has broken and screw is gone.

Post by: Sam Ho, Jul 17, 2016 in forum: Troubleshooting

Post

Ok, I reinstall the matter control (another version), now can connect to printer.

Post by: Sam Ho, Jul 16, 2016 in forum: Troubleshooting

Thread

My 3D printer Y-axis bell has broken but there is no replacement part available in ROBO shop.

Thread by: Sam Ho, Jul 16, 2016, 7 replies, in forum: Troubleshooting

Post

Could you kindly advise from where I can get the start up materials?

Post by: Sam Ho, Jul 10, 2016 in forum: Troubleshooting

Thread

I was using my pc to connect to my ROBO 3D R1 printer. Today I use my laptop but totally could my connect the printer. There is no printer for my...

Thread by: Sam Ho, Jul 10, 2016, 5 replies, in forum: Troubleshooting