1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by sandman450

  1. sandman450
    Post

    Lack of parts for the Robo 3D R1+ Unacceptable

    Shattered.
    Post by: sandman450, Feb 24, 2017 in forum: General Questions
  2. sandman450
    Thread

    Lack of parts for the Robo 3D R1+ Unacceptable

    I don't know about you guys but I am starting to feel like a red headed stepchild due to Robo 3D's lack of parts for the Robo 3D R1+. I know they...
    Thread by: sandman450, Feb 24, 2017, 10 replies, in forum: General Questions
  3. sandman450
    Post

    Solved Printer Goes Nuts After Printing Raft

    I never had a sealed chamber around my printer or anything on my first Robo 3d R1+. I would just set it up, walk away and keep the door shut to my...
    Post by: sandman450, Aug 12, 2016 in forum: Troubleshooting
  4. sandman450
    Post

    Solved Printer Goes Nuts After Printing Raft

    Just to let everyone know that helped me out. The issue ended up being the V 2.0 firmware after all. I flashed it back to the Lead Screw Upgrade...
    Post by: sandman450, Aug 12, 2016 in forum: Troubleshooting
  5. sandman450
    Post

    Solved Printer Goes Nuts After Printing Raft

    I had no issues flashing the firmware. I did the global edit as suggested in a comment at the bottom of the page and it went off without a hitch....
    Post by: sandman450, Aug 10, 2016 in forum: Troubleshooting
  6. sandman450
    Post

    Solved Printer Goes Nuts After Printing Raft

    I downloaded and flashed the Robo 3D R1+ firmware, Version 2 from here; http://guide.robo3d.com/Wiki/ROBO_3D_Firmware_Release_Notes I downloaded...
    Post by: sandman450, Aug 10, 2016 in forum: Troubleshooting
  7. sandman450
    Post

    Solved Printer Goes Nuts After Printing Raft

    Thanks for the replies. As far as anything I have done to the printer, just unboxed it, flashed the V2 firmware, and loaded up filament. I tried...
    Post by: sandman450, Aug 10, 2016 in forum: Troubleshooting
  8. sandman450
    Thread

    Solved Printer Goes Nuts After Printing Raft

    Hey all, I just received my second Robo 3D R1+ Printer yesterday and I have not gotten one successful print in 14 attempts. I have read through...
    Thread by: sandman450, Aug 10, 2016, 18 replies, in forum: Troubleshooting
  9. sandman450
    Post

    E3D v6 Information, Installation Guides, and Review

    Finally got my E3D V6 Hot end installed and wired in on my Robo 3D V1+. Everything appears to be working except for one issue. Whenever I try to ,...
    Post by: sandman450, Apr 21, 2016 in forum: Mods and Upgrades
  10. sandman450
    Post

    E3D v6 Information, Installation Guides, and Review

    Hi Guys, total newb to 3D printing here and currently in the middle of upgrading my Robo 3D R1+ to the E3D V6 Hot end. Is it possible to use the...
    Post by: sandman450, Apr 18, 2016 in forum: Mods and Upgrades