1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by stormdrmmr

  1. stormdrmmr
    Post

    Solved Heated bed reads @85*

    Already on it. Totally unrelated to this thread. I read where you never use the cover. Do you have a gcode file for the spool holder you use?
    Post by: stormdrmmr, Feb 9, 2022 in forum: Troubleshooting
  2. stormdrmmr
    Post

    Solved Heated bed reads @85*

    Was The RAMPS board
    Post by: stormdrmmr, Feb 8, 2022 in forum: Troubleshooting
  3. stormdrmmr
    Post

    Solved Heated bed reads @85*

    Thanks Mark. A RAMPS board is on the way.
    Post by: stormdrmmr, Jan 22, 2022 in forum: Troubleshooting
  4. stormdrmmr
    Thread

    Solved Heated bed reads @85*

    Bought a refurbished R1+ in December from B&H Photo. Installed MC1.5 from sd card. Calibration circle and first few prints went fine. After...
    Thread by: stormdrmmr, Jan 20, 2022, 6 replies, in forum: Troubleshooting
  5. stormdrmmr
    Thread

    Solved Marlin 2.0 won't compile

    Set configration.h for reprap smart discount controller and for new thermistors. went to verify and got "error compiling for mega or mega 2560"...
    Thread by: stormdrmmr, Jan 19, 2022, 1 replies, in forum: Troubleshooting