1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Recent Content by Timothy Tiller

  1. Timothy Tiller
    Post

    Cura 2.5 fails after install

    Yep did that and it works, need to fine tune the settings to get a good first layer, I think I am making progress. Thanks.
    Post by: Timothy Tiller, Jun 8, 2017 in forum: General Questions
  2. Timothy Tiller
    Post

    Robo R2 Bed Question

    When I contacted Tech Support over my bed not heating he told me the bed on the R2 was aluminum with a PEI sheet covering it. That is why it takes...
    Post by: Timothy Tiller, Jun 7, 2017 in forum: General Questions
  3. Timothy Tiller
    Post

    Cura 2.5 fails after install

    I deleted 2.5 and reloaded 2.3 but there is no printer profile for the R2, just the C2.
    Post by: Timothy Tiller, Jun 7, 2017 in forum: General Questions
  4. Timothy Tiller
    Post

    R2 Print Bed

    When I called in on Friday about my bed not heating that is what the tech told me...
    Post by: Timothy Tiller, Jun 7, 2017 in forum: Troubleshooting
  5. Timothy Tiller
    Thread

    Cura 2.5 fails after install

    I downloaded Cura 2.5 from the robo website and when I try to run it it won.t giving an error saying no disk in drive D. they it freezes my...
    Thread by: Timothy Tiller, Jun 7, 2017, 13 replies, in forum: General Questions
  6. Timothy Tiller
    Post

    R2 Print Bed

    I was told by a tech that the R2 has a aluminum bed not glass. that is why it takes longer to heat than the R1.
    Post by: Timothy Tiller, Jun 7, 2017 in forum: Troubleshooting