1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Marlin R2 Firmware

Discussion in 'Troubleshooting' started by DUSTIN MALCHOW, Jun 24, 2020.

  1. DUSTIN MALCHOW

    DUSTIN MALCHOW New Member

    Joined:
    Jun 24, 2020
    Messages:
    2
    Likes Received:
    0
    I dropped a spool of filament on my power cable while my R2 was running. Long story short my main board fried out. I couldn't find a replacement so I ordered the C2 Board and it seem to be working. The problem with it is the build volume is stuck to the C2. I was wondering if someone could send me a clone of their Marlin R2 firmware.
     
    #1 DUSTIN MALCHOW, Jun 24, 2020
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    Wrong forum section -- moved for you.
     
    #2 mark tomlinson, Jun 24, 2020
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #3 mark tomlinson, Jun 24, 2020
  4. DUSTIN MALCHOW

    DUSTIN MALCHOW New Member

    Joined:
    Jun 24, 2020
    Messages:
    2
    Likes Received:
    0
    Sorry about that, new to the forum and the printer. Much appreciated for the help.
     
    #4 DUSTIN MALCHOW, Jun 24, 2020
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    No worries, good luck.
     
    #5 mark tomlinson, Jun 24, 2020

Share This Page