1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Answered Wire harness issue

Discussion in 'Troubleshooting' started by MOwens5150, Jan 30, 2016.

  1. MOwens5150

    MOwens5150 New Member

    Joined:
    Mar 6, 2015
    Messages:
    16
    Likes Received:
    2
    The green wire came out of the harness that goes to the print head motor. The metal piece is still in the harness. How do I get it out to fix or is there an easier way to reattach?
     
    #1 MOwens5150, Jan 30, 2016
  2. afat08

    afat08 Member

    Joined:
    Jan 9, 2016
    Messages:
    38
    Likes Received:
    2
    Any pictures?
     
    #2 afat08, Jan 30, 2016
  3. MOwens5150

    MOwens5150 New Member

    Joined:
    Mar 6, 2015
    Messages:
    16
    Likes Received:
    2
    Adding picture
     

    Attached Files:

    #3 MOwens5150, Jan 30, 2016
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Those are almost impossible to repair. It might be possible to solder the wire back onto the connector.

    I'd submit a replacement part request through robo
     
    #4 Mike Kelly, Feb 1, 2016
    Geof likes this.
  5. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    I'd have to agree, without specific pin tools those are about impossible to fix. I have a pin removal set and its still difficult, I broke the connector trying :)
     
    #5 Geof, Feb 1, 2016
  6. MOwens5150

    MOwens5150 New Member

    Joined:
    Mar 6, 2015
    Messages:
    16
    Likes Received:
    2
    Thanks all Robo is sending me a new harness.
     
    #6 MOwens5150, Feb 2, 2016
    mark tomlinson likes this.

Share This Page