1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Ghosting and overhangs.

Discussion in 'Troubleshooting' started by Oisin, Apr 28, 2016.

Page 2 of 2
  1. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Well, so much for that advice then I was printing faster :)
     
    #21 mark tomlinson, Apr 28, 2016
  2. Oisin

    Oisin Member

    Joined:
    Apr 14, 2015
    Messages:
    384
    Likes Received:
    23
    Hey it's good advice! Now I know I *should* be able to print faster without these issues.
     
    #22 Oisin, Apr 28, 2016
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Changing the speed (up or down) will potentially help if it is resonance.
    Just a thought.
     
    #23 mark tomlinson, Apr 28, 2016
  4. Oisin

    Oisin Member

    Joined:
    Apr 14, 2015
    Messages:
    384
    Likes Received:
    23
    Ok I'll test it at 15mm/s, 40mm/s and 65mm/s and see what happens.
     
    #24 Oisin, Apr 28, 2016
    mark tomlinson likes this.
  5. pitcjd01

    pitcjd01 New Member

    Joined:
    Mar 22, 2015
    Messages:
    9
    Likes Received:
    3
    Ghosting can be caused by vibration and play in the end stops. Check that your pulleys are all securely fixed to the stepper motor shafts, that there is little to no play in your belts, and check your z-axis smooth rods to see that they are held securely in the lid by vibration dampeners.

    Sent from my SM-G935P using Tapatalk
     
    #25 pitcjd01, Apr 29, 2016
Page 2 of 2

Share This Page