Separate names with a comma.
Do you have a meter?
Maybe the polarity of the output is reversed?
Worth a check -- if not you are right it is probably not enough current to...
There are some really good videos in this thread (R1, not R1+ but for 90% of things it is identical)...
So turn it back on and it should reset itself.
Reboot the printer essentially and reconnect with your software and tell it to HOME.
You can swap it on the RAMPS board too :) Nothing keyed there.
Been a bit since it was fired up, but up and off it goes. No worries.
Duplicating some DLP models while troubleshooting the DLP printer....
The normal drivers are the A4988, the DRV8825 SHOULD be interchangeable.
Not sure what you mean there.
is it "stuck" and not moving?
Is it just too low? (the FAQ link top of the forum has some help regarding Z...
Actually the stock ones if it runs backwards I usually just swap the entire connector 180 degrees :)
If the RAMPS itself is not the issue then the stepper drivers are likely your next best bet for a failure.
Assuming the hardware is identical, no. You went with the RAMPS 1.6, I can't say if that requires a firmware tweak or not (I suspect NOT, but I...
I am having a chat this Friday with Kenneth Jiang, TSD founder.
If anyone else using this (or who has experimented with it) has any feedback they...
Good luck, I personally have not touched kisslicer in a long time.
Someone else may have experience with it.
Ah, that makes more sense.
Good work -- getting from 1.0 to 1.1.x is not a simple hop on this printer.
Buzzing means either the stepper is bad or (more likely) the stepper driver needs to be adjusted to send more current (or -- replaced).
Wow, a record thread resurrection. 4+ years old ;)
Post a new member introduction thread yourself!
That or the connections (ribbon cable connectors) to the LCD or the RAMPS are loose or bad.
That one is in the FAQ post (see the main troubleshooting forum.
The others are probably more specific to the changes you made.
I can't help...
I can't imagine them coming back at a later date and doing another update.
The R2/C2/R1 boat has sailed and the E3 (EDU) printer is the only one...