1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. John Wohlfeil
    Thread

    Hotend Clogged and other challenges

    I have a clogged hot end. Filament is stuck down in there. When I remove the hot end assembly by loosening the single hex screw in front, the...
    Thread by: John Wohlfeil, Nov 26, 2017, 6 replies, in forum: Troubleshooting
  2. John Wohlfeil
    Thread

    Heated bed temperature changing, prints not sticking

    I have been using my Robo R2 without any issues since I got it about a month ago. Now, in the midst of a bunch of testing, new accessories, etc....
    Thread by: John Wohlfeil, Nov 23, 2017, 9 replies, in forum: Troubleshooting
  3. John Wohlfeil
    Thread

    Anyone have experience with Palette+ ?

    I just got the announcement for the Palette+ and its availability for use with Robo R2. Does anyone have any experience with the Palette? or...
    Thread by: John Wohlfeil, Nov 14, 2017, 91 replies, in forum: General Questions
  4. John Wohlfeil
    Thread

    Robo PLA won't fit my R2

    I am brand new to this, I got my R2 (and I love it so far), and I wasn't sure about "off brand" PLA so I ordered ROBO PLA to get me started ......
    Thread by: John Wohlfeil, Oct 15, 2017, 1 replies, in forum: Filament
Showing results 1 to 4 of 4
Search Again