1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Carlos144Green
    Thread

    Unanswered New Screen Troubles

    So I had a school project and was allowed to keep the LCD screen from it. I had the bright idea of just swapping out the old unresponsive screen...
    Thread by: Carlos144Green, May 8, 2020, 4 replies, in forum: Troubleshooting
  2. Carlos144Green
    Thread

    Mouse on screen

    I was wondering if it was possible to hook up a mouse to my screen since the screen isn't responsive any longer.
    Thread by: Carlos144Green, May 8, 2020, 2 replies, in forum: Mods and Upgrades
  3. Carlos144Green
    Thread

    Unresolved LCD Screen Non-responsive

    Hello! I'm back with another problem... So recently I decided to turn off my printer the proper way with the shutdown button through the menu of...
    Thread by: Carlos144Green, Nov 8, 2019, 8 replies, in forum: Troubleshooting
  4. Carlos144Green
    Thread

    Partial Answer Many Layers Print Poorly

    So right off the bat, I know that this is not a hotend problem because I have replaced just about every part possible on the hotend with new parts...
    Thread by: Carlos144Green, Sep 5, 2019, 9 replies, in forum: Troubleshooting
  5. Carlos144Green
    Thread

    Solved Extruding gear doesn't work with new part

    Recently I discovered my printer had a cracked part so I 3d printed a new part Robo designed. I popped it in and fit just fine. I ran a few tests...
    Thread by: Carlos144Green, Apr 26, 2019, 4 replies, in forum: Troubleshooting
  6. Carlos144Green
    Thread

    Solved Prints come out slightly angled or stretched

    I don't know for how long but I have noticed this with my prints. Squares and other orthogonal shapes are clearly not at 90 degrees angles. My...
    Thread by: Carlos144Green, Apr 21, 2019, 10 replies, in forum: Troubleshooting
  7. Carlos144Green
    Thread

    Solved Filament not extruding even with new extruder

    I recently ran into problems with extruding filament. My printer extruded like it was partially clogged so I replaced the 4mm nozzle with another...
    Thread by: Carlos144Green, Apr 12, 2019, 37 replies, in forum: Troubleshooting
  8. Carlos144Green
    Thread

    Help with setting up Octolapse

    Hi, I am fairly experienced with 3d printing but I have never ventured into the Octoprint area of 3d printing. I recently found out that the...
    Thread by: Carlos144Green, Mar 19, 2019, 5 replies, in forum: General Questions
Showing results 1 to 8 of 8
Search Again