1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Chris Pooley
    Post

    Partial Answer Print Stuck on Z1

    I’m not sure if the z steppers are failing because I can move them manually and on my lcd screen it just reads 1 rather than the usual decimal
    Post by: Chris Pooley, Oct 24, 2017 in forum: Troubleshooting
  2. Chris Pooley
    Post

    Partial Answer Print Stuck on Z1

    R1+
    Post by: Chris Pooley, Oct 24, 2017 in forum: Troubleshooting
  3. Chris Pooley
    Post

    Partial Answer Print Stuck on Z1

    It was fine straight after I changed the firmware and levelled the bed. I had a print get half way through before I stopped it. So I was working...
    Post by: Chris Pooley, Oct 24, 2017 in forum: Troubleshooting
  4. Chris Pooley
    Post

    Partial Answer Print Stuck on Z1

    I have used the latest firmware from the MESH thread by whereswaldo, I have the R1 Plus and I haven't tried reverting back to standard firmware as...
    Post by: Chris Pooley, Oct 24, 2017 in forum: Troubleshooting
  5. Chris Pooley
    Thread

    Partial Answer Print Stuck on Z1

    Every time I try to print now every model gets stuck on Z1. So each level is printed on the same level rather than going up with the layer height....
    Thread by: Chris Pooley, Oct 24, 2017, 9 replies, in forum: Troubleshooting
  6. Chris Pooley
    Post

    Troubleshooting Marlin install

    I've inserted it and now getting this.
    Post by: Chris Pooley, Oct 19, 2017 in forum: Mods and Upgrades
  7. Chris Pooley
    Post

    Troubleshooting Marlin install

    I have the reprap XXL controller . I have downloaded the file but not sure how to add this to the firmware?
    Post by: Chris Pooley, Oct 19, 2017 in forum: Mods and Upgrades
  8. Chris Pooley
    Post

    Troubleshooting Marlin install

    I now get this. This makes even less sense now. lol Wouldn't let me paste in so I have uploaded a note pad doc
    Post by: Chris Pooley, Oct 19, 2017 in forum: Mods and Upgrades
  9. Chris Pooley
    Thread

    Troubleshooting Marlin install

    Just trying to upload this to my printer but keep getting this error messafe even though I believe the board is correct and I am on the correct...
    Thread by: Chris Pooley, Oct 19, 2017, 14 replies, in forum: Mods and Upgrades
  10. Chris Pooley
    Thread

    Unresolved Print Popping off of Bed. Help Please

    Hi, When printing the first 50 or so layers stick perfectly, but after that it just seems to pop off and then just make a mess of everything,...
    Thread by: Chris Pooley, Dec 15, 2016, 1 replies, in forum: Troubleshooting
Showing results 1 to 10 of 10
Search Again