1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Laura Kapp
    Post

    Solved COM showing up but won't connect

    Go figure! Thank you for pointing me in the right direction!
    Post by: Laura Kapp, Mar 6, 2019 in forum: Troubleshooting
  2. Laura Kapp
    Post

    Solved COM showing up but won't connect

    How do I do this?
    Post by: Laura Kapp, Mar 6, 2019 in forum: Troubleshooting
  3. Laura Kapp
    Thread

    Solved COM showing up but won't connect

    My R1+ has been sitting around for a few months and I just recently put a file together to start printing again I realized my USB cord was broken...
    Thread by: Laura Kapp, Mar 5, 2019, 4 replies, in forum: Troubleshooting
  4. Laura Kapp
    Post

    Solved Prints Failing - Need Help Understanding Why

    Mine seems to be the newer version. It was purchased in November 2016 and does have a screw that secures it to the block like what is shown in the...
    Post by: Laura Kapp, Apr 9, 2018 in forum: Troubleshooting
  5. Laura Kapp
    Post

    Solved Prints Failing - Need Help Understanding Why

    Good to know. Glad I went ahead and ordered the replacement head. Is there a way to replace the thermistor without purchasing a new hot end entirely?
    Post by: Laura Kapp, Apr 9, 2018 in forum: Troubleshooting
  6. Laura Kapp
    Post

    Solved Prints Failing - Need Help Understanding Why

    Thank you!!! Since the issue is only happening occasionally any guess what the problem might be (fan or thermistor)? I went ahead and ordered a...
    Post by: Laura Kapp, Apr 9, 2018 in forum: Troubleshooting
  7. Laura Kapp
    Post

    Solved Prints Failing - Need Help Understanding Why

    Not sure how much an image will help, files basically get anywhere from 10-20% finished and then fail. However, sometimes (on a good day by the...
    Post by: Laura Kapp, Apr 9, 2018 in forum: Troubleshooting
  8. Laura Kapp
    Post

    Solved Prints Failing - Need Help Understanding Why

    Apologies. The error didn't pop up until after I canceled the print, was hoping to reconcile it when I posted the thread The error read:...
    Post by: Laura Kapp, Apr 9, 2018 in forum: Troubleshooting
  9. Laura Kapp
    Thread

    Solved Prints Failing - Need Help Understanding Why

    I'm still learning the ins and outs of my Robo R+1 I've had it for a year and a half now but lately prints have been failing mid print. I've been...
    Thread by: Laura Kapp, Apr 8, 2018, 16 replies, in forum: Troubleshooting
Showing results 1 to 9 of 9
Search Again