1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved COM showing up but won't connect

Discussion in 'Troubleshooting' started by Laura Kapp, Mar 5, 2019.

  1. Laura Kapp

    Laura Kapp New Member

    Joined:
    Dec 9, 2016
    Messages:
    9
    Likes Received:
    0
    My R1+ has been sitting around for a few months and I just recently put a file together to start printing again
    I realized my USB cord was broken so I ordered a new one
    After I was using a new cord I still couldn't get the COM to load so I replaced the arduino thinking I may have broken the connection
    Now, with the new arduino, the COM is coming up for manual configuration in Matter Control but it just stays in "Attempting to connect..." mode and won't move past it.

    Not sure what is the issue. I have all the updated drivers and have uninstalled the arduino and reinstalled several times (with reboots) Anyone have any ideas?
     
    #1 Laura Kapp, Mar 5, 2019
  2. WheresWaldo

    WheresWaldo Volunteer ( ͠° ͟ʖ ͡°)
    Staff Member

    Joined:
    Feb 18, 2015
    Messages:
    5,905
    Likes Received:
    3,593
    Did you flash the Robo firmware to the new Arduino board?
     
    #2 WheresWaldo, Mar 6, 2019
    Laura Kapp, mark tomlinson and Geof like this.
  3. Laura Kapp

    Laura Kapp New Member

    Joined:
    Dec 9, 2016
    Messages:
    9
    Likes Received:
    0
    How do I do this?
     
    #3 Laura Kapp, Mar 6, 2019
  4. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,912
    Likes Received:
    7,338
    #4 mark tomlinson, Mar 6, 2019
    Laura Kapp likes this.
  5. Laura Kapp

    Laura Kapp New Member

    Joined:
    Dec 9, 2016
    Messages:
    9
    Likes Received:
    0
    Go figure!
    Thank you for pointing me in the right direction!
     
    #5 Laura Kapp, Mar 6, 2019

Share This Page