Separate names with a comma.
a big thank you for your help, I replaced G36 with G28 and everything is ok, my problem is solved
Could you give me a fonctional start g code on r2 formation tests
I can just replace G36 with a G28 follower by G29?
So what should I add exactly and where in the gcode I repeat that I am beginner thank you
Cura 4.2.1 by choosing as a custom printer FDM and set the parameters of r2 , and removing all Gcode.
So there is no gcode in cura...
here is my octoprint gcode before just start
; set to millimeters
; set to absolute mode
; zero extruder
; turn off fans
Yes I have again made an adjustment of the Z axis, always the same problem.
First of all thank you for all your answers.
I run under Windows 10 x64. I just tried an impression through the USB key, the result is the...
Beginner I bought a r2 your community helped me a lot for all my problems.
So I installed cura 4.2.1 by choosing as a custom printer FDM...