1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
Page 9 of 9
  1. Lance Weston
    Thread

    Stepper motor question

    I have attached a PDF that explains what the steppers need in current. The R2 stepper (17HS4402) rating is 1.3 amps. The Robo board uses an...
    Thread by: Lance Weston, Dec 6, 2020, 6 replies, in forum: General Questions
  2. Lance Weston
    Thread

    Found new source of stringing

    I had found in the past that stringing would often go away with the change of hotends. With the last nozzles I purchased came .4mm needles. To...
    Thread by: Lance Weston, Nov 27, 2020, 0 replies, in forum: Troubleshooting
  3. Lance Weston
    Post

    Help with Gantry Rebuild and diagnostic of layer alignment issue

    This problem is often tied to over extrusion on my machines. Depending on the filament I have gone down to 84% extrusion on the outer layer and...
    Post by: Lance Weston, Nov 27, 2020 in forum: Troubleshooting
  4. Lance Weston
    Post

    OctoPrint: 1.4.0-rc6

    Sounds like something you can test for all of us. Just make a backup of the sd card then do the update and let us know.
    Post by: Lance Weston, Nov 21, 2020 in forum: Software
  5. Lance Weston
    Thread

    Light weight improved E3D J6 shroud works with 48mm steppers

    I use the Cheap Chinese E3D J6 (wade) hotends. (I just ordered on eBay, 4 for $25 delivered ) This shroud is for that size hotend. I could be...
    Thread by: Lance Weston, Nov 19, 2020, 0 replies, in forum: Mods and Upgrades
  6. Lance Weston
    Post

    Garolite Bed for Robo R2

    I had purchased 12x12 glass a while ago: https://www.storesupply.com/pc-12926-1123-12-x-12-x-316-tempered-glass-panels-67111.aspx I used the glue...
    Post by: Lance Weston, Nov 16, 2020 in forum: Show and Tell
  7. Lance Weston
    Post

    R2 Extruder Mod

    I put your mod on my extruder stepper and it went from 150C to cold. I liked it so much that I put heatsinks and fans on my x,y steppers and now...
    Post by: Lance Weston, Nov 15, 2020 in forum: Mods and Upgrades
Find older messages
Showing results 161 to 167 of 167
Search Again
Page 9 of 9