1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. KingaLing
    Thread

    Leveling Bed

    What are you guys using to level out the bed, shims etc, I was thinking of using some sticky tack so I can put it on each bolt and then push down...
    Thread by: KingaLing, Dec 30, 2017, 1 replies, in forum: General Questions
  2. KingaLing
    Thread

    Solved Z Offset Calibration Stays at Left Corner

    I have a question, I have been unable to use my C2 for a few months as I travel for work and did not have the time to print. Now that I have a...
    Thread by: KingaLing, Dec 30, 2017, 2 replies, in forum: Troubleshooting
  3. KingaLing
    Thread

    Unanswered Remote Access Printer Using Robo App

    I have a quick and maybe simple question, is there a way to access printer remotely through the robo3D app? I know it is Octoprint, and have...
    Thread by: KingaLing, Dec 23, 2016, 8 replies, in forum: Troubleshooting
  4. KingaLing
    Thread

    Answered Nozzle Digging Into Print (Noob)

    First, let me thank everyone here in this forum, as I just got my Robo + (refurb) today, and I was able to install LCD Board and E3D V6, on my...
    Thread by: KingaLing, Apr 23, 2016, 22 replies, in forum: Troubleshooting
Showing results 1 to 4 of 4
Search Again