Separate names with a comma.
That's a reasonable value. I think it's 100kohms at 20C
A loose connection will cause a short drop causing it to "Temp Fall"
Not super helpful there.
Print settings, speeds, pictures, etc.
FYI the upload a file option on here is good for pictures as well
I'd go for one like the Hobb Goblin that has precision cut grooves....
Looks good. How are you homing? Tim recently dropped the price of the Mini IR:...
Measure the voltage coming in
Measure the resistance. I doubt it's bad, unless a lead breaks they're pretty fool proof. Probably just a loose connection. Occams razor and all
As long as you're careful and don't fry any electronics your warranty should stay in tact. Just know your limits and don't exceed them without help
This is great! good work
Lookin good. I don't have any plans on the cable chain. I'm not a huge fan of the design because i don't think it really has anywhere to go once...
@Harry Shows 51 posts by him. The search is broken and has been for a while now
You can find them on google as well
Something about the forum search is broken. You could find it using a Google search with your username and use an advanced search modifier for...
Ah ok yeah that makes sense. I'm forgetting most of you are using the stock autoleveling switches.
If it was me I'd remove those switches and...
Might as well be. I have one that makes no noise and I'm not convinced air is actually moving across it
Wasn't this caused by the wrong steps per mm? Mine does not do this at all
The E3Dv6 nozzles fit great in the hex. No need for a new hot end
Well there are quiet 25mm fans but they move like no air.
Does your terminal log show any errors?
If you don't pre-heat before a print does it work?
I clean mine like once every 6 months, if that often
The 4 is the value it goes to before the mesh leveling and for each step.