1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Drmike
    Thread

    Success at last!

    I started out with a lot of problems, with most of my posts to this forum being questions about why things were not working. I had both hardware...
    Thread by: Drmike, Apr 10, 2016, 0 replies, in forum: Show and Tell
  2. Drmike
    Thread

    Answered Retraction Formula

    I've successfully got my object to print with my own gcode, but I have lots of blobs getting in the way. I realize I need to add retraction...
    Thread by: Drmike, Apr 8, 2016, 2 replies, in forum: Troubleshooting
  3. Drmike
    Thread

    Anyone use G2/G3 on RoBo?

    I ran into trouble with my stl to gcode conversion so I decided to create my own gcode generator since my shape is essentially mathematical. After...
    Thread by: Drmike, Apr 3, 2016, 34 replies, in forum: Software
  4. Drmike
    Thread

    Solved How to calibrate Z axis motion

    So I got a new power supply and now I can print the MatterControl calibration ring all the way through. The X and Y motions are perfect, and the...
    Thread by: Drmike, Feb 21, 2016, 7 replies, in forum: Troubleshooting
  5. Drmike
    Thread

    MatterControl and Slic3er (and Cura)

    I am attempting to compare the slicers in MatterControl, but Slic3er gives me an error when I try to look at layer view. It says "Slicing Error....
    Thread by: Drmike, Feb 16, 2016, 4 replies, in forum: Software
  6. Drmike
    Thread

    Answered Power supply or overheating?

    I got my first T-glase print to work and it was more than half way through when the lights went out on the 3D. The fans were still running, and...
    Thread by: Drmike, Feb 15, 2016, 13 replies, in forum: Troubleshooting
  7. Drmike
    Thread

    Unanswered Z axis offset way off

    I've finally got a few things working, but when the device goes to auto level it is way, way off. I've attached a picture of where the z axis...
    Thread by: Drmike, Feb 13, 2016, 7 replies, in forum: Troubleshooting
  8. Drmike
    Thread

    Solved Cura Ubuntu 14.04

    I am attempting to connect to a 3D+ via Cura 15.04 on Ubuntu 14.04. I have set the baud rate to 250000 and Cura sees /dev/ttyACM0. I am also...
    Thread by: Drmike, Feb 9, 2016, 8 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again