1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. bmillz
    Post

    PLA Robo PLA

    Thanks, Mark.
    Post by: bmillz, Apr 22, 2016 in forum: Printing Filament
  2. bmillz
    Thread

    PLA Robo PLA

    I'm a full on noob with this stuff but after overcoming some initial issues, I'm having a blast. I have tried a few prints with the PLA blue that...
    Thread by: bmillz, Apr 22, 2016, 2 replies, in forum: Printing Filament
  3. bmillz
    Post

    Solved Too light to be a boat anchor?

    I should have known. Shipping is really hard on stuff. I went through and disconnected and reconnected the electrical connections and it's...
    Post by: bmillz, Apr 20, 2016 in forum: Troubleshooting
  4. bmillz
    Post

    Solved Too light to be a boat anchor?

    Thank you, Chuck. Tech Support has been pretty helpful and I have an appointment tomorrow with a level 2 Tech to try and figure out what is...
    Post by: bmillz, Apr 20, 2016 in forum: Troubleshooting
  5. bmillz
    Post

    Solved Too light to be a boat anchor?

    It's becoming quite entertaining to watch. I may have to keep it just for the lolz. A friend of mine had an old Chihuahua that was blind and...
    Post by: bmillz, Apr 20, 2016 in forum: Troubleshooting
  6. bmillz
    Thread

    Solved Too light to be a boat anchor?

    I'm about to throw this thing through the window and out into the yard. -.- I had no idea that ready out of the box meant troubleshooting for...
    Thread by: bmillz, Apr 20, 2016, 6 replies, in forum: Troubleshooting
  7. bmillz
    Post

    Solved Oops! Printer could not be detected...

    I called Tech Support and got this resolved. The MatterControl software auto-install of the drivers does not always work. I was sent an e-mail...
    Post by: bmillz, Apr 20, 2016 in forum: Troubleshooting
  8. bmillz
    Thread

    Solved Oops! Printer could not be detected...

    I followed the video tutorial. I have shut MatterControl down and restarted it, shut the computer down and restarted it, tried every combo of...
    Thread by: bmillz, Apr 20, 2016, 2 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again