1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. TheKoopaGaming
    Thread

    Answered Autoleveling not working after RAMPS replacement

    Hey, you guys have been very helpful in the past, hoping you can help me solve this problem. I just replaced my RAMPS board, and everything seems...
    Thread by: TheKoopaGaming, Oct 3, 2018, 4 replies, in forum: Troubleshooting
  2. TheKoopaGaming
    Thread

    Unanswered X-Axis Shifting

    Hello Robo Community I have been having a problem with x-axis shifting. Whenever I try and print a model that takes up most of the build plate on...
    Thread by: TheKoopaGaming, May 9, 2017, 10 replies, in forum: Troubleshooting
  3. TheKoopaGaming
    Thread

    Solved Problems Printing with PETG

    Hello Robo Community You have been very helpful to me in the past so I hope you can help me now. This is my first time printing with PETG and I am...
    Thread by: TheKoopaGaming, Apr 21, 2017, 3 replies, in forum: Troubleshooting
  4. TheKoopaGaming
    Thread

    Solved Layer Shifting

    Hello Forum! You have been very helpful in the past so I hope you can help now! Ever since I did a little maintenance on my printer (nothing...
    Thread by: TheKoopaGaming, Feb 24, 2017, 2 replies, in forum: Troubleshooting
  5. TheKoopaGaming
    Thread

    PEI Problem

    Hello- I've been reading up on using PEI and I just got some today. I installed it and went to test it out any nothing is sticking. I printing...
    Thread by: TheKoopaGaming, Sep 18, 2016, 10 replies, in forum: Mods and Upgrades
  6. TheKoopaGaming
    Thread

    Solved Bubbling on First Layer

    Hello- I have had my R1 PLUS for roughly a month and a half, and have loved it. My problem is that recently I have been noticing a lot of...
    Thread by: TheKoopaGaming, Sep 11, 2016, 10 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again