1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Robert T Loewen
    Thread

    Unanswered May have shorted pc fan and x endstop

    Only for a few seconds as I was trying to resolder and test the OC fan and I saw smoke pouring out of the robo3d r1 and cut power and started by...
    Thread by: Robert T Loewen, Nov 29, 2016, 10 replies, in forum: Troubleshooting
  2. Robert T Loewen
    Thread

    Unresolved Would anyone be able to help via skype?

    Took the hot end out and cleared to jammed filament and have put the hotend back in my r1 but need some help getting back up and running and...
    Thread by: Robert T Loewen, Nov 27, 2016, 42 replies, in forum: Troubleshooting
  3. Robert T Loewen
    Thread

    Solved Mildly impressed with myself

    Not sure how I pulled that off[IMG] but somehow got two pieces of filament stuck in the hotend. Going to soak the hotend in acetone not sure for...
    Thread by: Robert T Loewen, Nov 25, 2016, 0 replies, in forum: Troubleshooting
  4. Robert T Loewen
    Thread

    Unresolved stl file trouble

    so i have an stl file that i want to print but the slicer is missing the text and was wondering if someone could help me get this figured out....
    Thread by: Robert T Loewen, Nov 22, 2016, 5 replies, in forum: Troubleshooting
  5. Robert T Loewen
    Thread

    Solved Z scraping the print

    Not quite sure what's going on here but my z offset is 1 [IMG] this is the LCD case for the rip rap xxl screen with Sd card reader Sent from my...
    Thread by: Robert T Loewen, Nov 14, 2016, 45 replies, in forum: Troubleshooting
  6. Robert T Loewen
    Thread

    Solved Thanks tech support

    Thank you to robo Robert and don for helping me get my r1 reliably printing for the first time. Had it for a while but never had the time to fix...
    Thread by: Robert T Loewen, Nov 11, 2016, 7 replies, in forum: Troubleshooting
Showing results 1 to 6 of 6
Search Again