1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Domenic
    Thread

    Partial Answer Layer lines on my prints are not even

    So for a long tome now my layers have been “misaligned” I’m not quite sure how to explain it except layer lines. At first I thought it was z...
    Thread by: Domenic, Nov 22, 2018, 36 replies, in forum: Troubleshooting
  2. Domenic
    Thread

    Solved Is it possible to replace the fans in the power supply box

    I have had my r1+ for a little under 2 years and it has grow to become very very loud. Just wondering if anyone has had this same problem and has...
    Thread by: Domenic, Jul 28, 2018, 9 replies, in forum: General Questions
  3. Domenic
    Thread

    Answered Burnt out Extruder fan

    Hi I am just wondering if anyone has run into the problem of a fan burning out or just breaking. I assume this was the cause of a filament clog...
    Thread by: Domenic, Aug 4, 2017, 10 replies, in forum: Troubleshooting
  4. Domenic
    Thread

    Answered Prints not printing correctly on first layer

    So ever since friday, when I installed a pane of PEI onto my build plate my prints have failed repeatedly. It is like the filament that is being...
    Thread by: Domenic, Feb 5, 2017, 6 replies, in forum: Troubleshooting
  5. Domenic
    Thread

    Answered Problem printing with octoprint and XXLCD

    This just happened out of the blue. I was messing around with the startup gcode and after every print this happens. It still prints fine. I am...
    Thread by: Domenic, Jan 27, 2017, 4 replies, in forum: Troubleshooting
  6. Domenic
    Thread

    PEI print bed upgrade

    So I have been doing a little reasearch on pei and for the most part it sounds like a cool upgrade. Right now I am using glue sticks. Painters...
    Thread by: Domenic, Jan 27, 2017, 6 replies, in forum: Mods and Upgrades
  7. Domenic
    Thread

    Partially Solved Vertical Ribbing on prints

    I have been printing lately and I have noticed that there are vertical ribs or columns in my prints that are quadrilaterals. Here are some...
    Thread by: Domenic, Jan 7, 2017, 12 replies, in forum: Troubleshooting
  8. Domenic
    Thread

    Turning printer off after print

    Letting my printer run for 10+ hours, even after the print is finished, can be a real pain. I was wondering if there is a way to automatically...
    Thread by: Domenic, Jan 3, 2017, 11 replies, in forum: Mods and Upgrades
Showing results 1 to 8 of 8
Search Again