1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Sam Moody
    Post

    Running on different slicers?

    Okay thanks for the help!
    Post by: Sam Moody, Feb 28, 2018 in forum: General Questions
  2. Sam Moody
    Post

    Running on different slicers?

    was there anything special you had to do to set up for the R2 or were you able to just put in the basic info?
    Post by: Sam Moody, Feb 28, 2018 in forum: General Questions
  3. Sam Moody
    Thread

    Running on different slicers?

    Has anybody tried to use a different slicer to run the R2? I have been looking at simplify 3D or cura 3.2 because they have a lot more options...
    Thread by: Sam Moody, Feb 28, 2018, 6 replies, in forum: General Questions
  4. Sam Moody
    Post

    Problems printing with TPU

    Yes they are, I've gone through semiflex, Cheetah, and was hoping the stiffer Hatchbox tpu would work better than it has so far
    Post by: Sam Moody, Dec 13, 2017 in forum: General Questions
  5. Sam Moody
    Post

    Problems printing with TPU

    okay I'll try that and hopefully something will work. Thanks for the help
    Post by: Sam Moody, Dec 13, 2017 in forum: General Questions
  6. Sam Moody
    Post

    Problems printing with TPU

    I'm currently running at 50mm/s because that was the recommended setting this is what the settings for cura are when I just set print speed print...
    Post by: Sam Moody, Dec 13, 2017 in forum: General Questions
  7. Sam Moody
    Thread

    Problems printing with TPU

    Has anyone else been trying to print with TPU and had success? I have been trying to print a rather long print(20 hours) with Hatchbox TPU and I...
    Thread by: Sam Moody, Dec 13, 2017, 8 replies, in forum: General Questions
  8. Sam Moody
    Post

    Filament run out detector not working

    Thanks for the advice! I'm running it through the proper hole, how do you remove the black box?
    Post by: Sam Moody, Sep 28, 2017 in forum: Troubleshooting
  9. Sam Moody
    Thread

    Filament run out detector not working

    My filament run out sensor doesn't seem to be working, I let a print run with out enough filament to finish and it didn't stop after the filament...
    Thread by: Sam Moody, Sep 27, 2017, 6 replies, in forum: Troubleshooting
  10. Sam Moody
    Post

    OS Corrupted in Update

    Thanks for the link! I have the file downloaded but I'm a little fuzzy on how to properly put that image on the sd card
    Post by: Sam Moody, Aug 25, 2017 in forum: Troubleshooting
  11. Sam Moody
    Thread

    OS Corrupted in Update

    I updated my printer and now the printer freezes shortly after booting up or just gets stuck at the Red robo screen. Can anyone help me with...
    Thread by: Sam Moody, Aug 25, 2017, 4 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again