1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Tilrico
    Post

    Answered Robo R1+ Print Bed

    Thank you all for your responses and help. I'll give this a try once I have a few more dings in the original print bed.
    Post by: Tilrico, Apr 16, 2018 in forum: Troubleshooting
  2. Tilrico
    Post

    Answered Robo R1+ Print Bed

    @WheresWaldo Do you have the exact size you cut it to? Once I place it on top how do I set my Z axis correctly? I assume I need a new offset.
    Post by: Tilrico, Apr 16, 2018 in forum: Troubleshooting
  3. Tilrico
    Thread

    Answered Robo R1+ Print Bed

    So I have had the Robo R1+ for a few months now. I have been printing on nearly something nearly every day. Today cleaning the Print bed I...
    Thread by: Tilrico, Apr 15, 2018, 9 replies, in forum: Troubleshooting
  4. Tilrico
    Post

    Solved UPS Requirements

    Thank you. Yea I have had the Kill-A-Watt mentioned to me for another application but I am not sure I would use it more than once or twice so...
    Post by: Tilrico, Apr 8, 2018 in forum: General Questions
  5. Tilrico
    Post

    Solved UPS Requirements

    Thank you guys, I was just a little unsure about the power draw ill hook mine up after this next print is finished.
    Post by: Tilrico, Apr 8, 2018 in forum: General Questions
  6. Tilrico
    Thread

    Solved UPS Requirements

    I would like to have my RoboR1+ behind a UPS (currently behind a basic surge protector) what is the max wattage it will pull? I currently have...
    Thread by: Tilrico, Apr 7, 2018, 6 replies, in forum: General Questions
  7. Tilrico
    Post

    Solved Clearing first bad clog.

    Well, thank you for all of your help guys. I just printed an oiler and pulled the filament last night. I will reseed the filament, get some...
    Post by: Tilrico, Feb 22, 2018 in forum: Troubleshooting
  8. Tilrico
    Post

    Solved Clearing first bad clog.

    So I appeared to have cleared the clog and now I am printing myself an oiler. Should I leave the PLA in after the print is done or pull and...
    Post by: Tilrico, Feb 21, 2018 in forum: Troubleshooting
  9. Tilrico
    Post

    Solved Clearing first bad clog.

    Thank, you! I will give it a try when I get home from work today. Is there some cooling setting that is default lower on Cura then on Matter...
    Post by: Tilrico, Feb 21, 2018 in forum: Troubleshooting
  10. Tilrico
    Post

    Solved Clearing first bad clog.

    It appears, on all of my prints thus far, that the fan is in working order. my first two prints completed (about an hour each using matter...
    Post by: Tilrico, Feb 21, 2018 in forum: Troubleshooting
  11. Tilrico
    Thread

    Solved Clearing first bad clog.

    (First 3d printer FYI) on my 3ed print, my hot end got clogged and I followed the steps set forth on the website and successfully cleared the...
    Thread by: Tilrico, Feb 21, 2018, 10 replies, in forum: Troubleshooting
Showing results 1 to 11 of 11
Search Again