1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!
Search Again
  1. Printer007
    Post

    R2 does not keep z calibration

    K, I'll copy the code and post it here, and I would definitely try out your hex file Lance! My print surface is the standard one that came with...
    Post by: Printer007, Jun 26, 2023 in forum: Troubleshooting
  2. Printer007
    Post

    R2 does not keep z calibration

    So I've messed around with manually setting the offset, but it seems that the actual issue is the print bed lowering at the start of the print....
    Post by: Printer007, Jun 16, 2023 in forum: Troubleshooting
  3. Printer007
    Post

    R2 does not keep z calibration

    So here are the steps I took Reset EEPROM Home offset -20 Probe offset -20 Advanced variables (not sure if these are important) S 0 T 0 X 8 Y 8...
    Post by: Printer007, Jun 13, 2023 in forum: Troubleshooting
  4. Printer007
    Post

    R2 does not keep z calibration

    I'm getting all firmware update files from github.Robo3D Marlin releases (weird formatting because of the forum)
    Post by: Printer007, Jun 7, 2023 in forum: Troubleshooting
  5. Printer007
    Post

    R2 does not keep z calibration

    1.2.6 - does not keep Z-Axis calibration 1.2.4 - causes the original issue of the bed lowering into the printer before a print, messing up the z...
    Post by: Printer007, Jun 7, 2023 in forum: Troubleshooting
  6. Printer007
    Post

    R2 does not keep z calibration

    See attached pic of the printer printing midair during the fine tune z-offset wizard. [ATTACH]
    Post by: Printer007, Jun 6, 2023 in forum: Troubleshooting
  7. Printer007
    Thread

    R2 does not keep z calibration

    Hi So I solved my previous issue where the printer would try to lower the bed thru the bottom of the printer when starting a print, however I'm...
    Thread by: Printer007, Jun 6, 2023, 13 replies, in forum: Troubleshooting
  8. Printer007
    Thread

    Solved Robo r2 bed lowering before print

    I just recently had a bad print and had to changed a belt on my Robo r2. Now the printer will lower the bed during the startup of a print. It...
    Thread by: Printer007, May 31, 2023, 3 replies, in forum: Troubleshooting
Showing results 1 to 8 of 8
Search Again