1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Partial Answer After printing, right and left side not at same level

Discussion in 'Troubleshooting' started by Kay Liu, Oct 24, 2017.

  1. Kay Liu

    Kay Liu New Member

    Joined:
    May 24, 2017
    Messages:
    15
    Likes Received:
    2
    Hi guys,
    I have a R1+. Recently when I try to print something tall, the printer always end up like left side at a very high level, but right side stuck in middle.(Picture attached) I can hand move both side rod down to bed level, though.
    Anybody could help me with this issue?
     

    Attached Files:

    #1 Kay Liu, Oct 24, 2017
  2. Geof

    Geof Volunteer Moderator
    Staff Member

    Joined:
    Nov 9, 2015
    Messages:
    6,757
    Likes Received:
    2,339
    Hello,
    I'd check to ensure the stepper driver is tuned correctly. The R1+ uses 2 independent stepper drivers (one for each z) so this can happen. You can also make sure that at the height its stopping that the motor isn't coming unplugged(unplug and replug cables).

    My bet is on stepper driver :D
     
    #2 Geof, Oct 24, 2017
    mark tomlinson likes this.

Share This Page