Anybody using KISSlicer?

Peter, If you can find Aquanet 3 Extra Super Hold in the purple can locally you should try it. Dry it 30 seconds or so at 50 or 60C and print PLA just warm at 30 or 40C or ABS print at 100C first 95C later layers. No electrical tape is needed. PLA will stick almost too well. Cleans off with water or alcohol. ABS pops off when cool. PLA may need some help by putting some drops of water around the print's edge. If the Z height is low and well squished the print bottom surface will be nice and shiny smooth.