1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Auto Bed Leveling

Discussion in 'Troubleshooting' started by ironbird61, May 8, 2015.

  1. ironbird61

    ironbird61 Guest

    I'm using the mac version of matter control and have all the updates that are available, but i don't see in the matter control software how to configure auto print leveling feature. I'm following the online instructions at this site: http://www.mattercontrol.com/articles/mattercontrol-guide-to-automatic-print-leveling

    I have a robo 3d purchased 2 months ago.
    In the matter control printer settings the box says it has hardware leveling.
     
    #1 ironbird61, May 8, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    #2 mark tomlinson, May 9, 2015

Share This Page