1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Auto level

Discussion in 'General Questions' started by Lance Weston, Jul 29, 2023.

  1. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    665
    Likes Received:
    231
    Does anyone know what the range of the auto level is?
     
    #1 Lance Weston, Jul 29, 2023
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,914
    Likes Received:
    7,338
    What do you mean by range?
     
    #2 mark tomlinson, Jul 31, 2023
  3. Lance Weston

    Lance Weston Active Member

    Joined:
    Jun 2, 2018
    Messages:
    665
    Likes Received:
    231

    I am fairly confused. I have a 36 point probing and a 10 layer fade. After I level manually and set the offset I get very consistent results, but not perfectly level results. If I now manually level during a skirt printing It will repeatably print level. I do not understand this behavior. This is my initial gcode script

    ; set K-factor PLA+
    M900 K64
    ; warm hotend
    M140 S80
    ; home
    G28
    ;heatup of bed
    M190 S60
    M190 S65
    ;M190 S75
    ;M190 S80
    ;M190 S85
    ;M190 S90
    ; set to millimeters
    G21
    ; home
    G28
    ; set absolute mode
    G90
    ; turn off fans
    M107
    ; move bed down 230mm
    G1 Z230 F300
    ; Home
    G28
    ; zero extruder
    G92 E0
    ; Home
    G28
    ; Robo Leveling
    G36
    ; home XY axis
    G28 X0 Y0
    ; zero extruder
    G92 E0
    ;heatup of extruder
    M109 S220
    ; move bed to printing position
    G1 Z0.2
    ;non blocking heatup of bed
    M140 S65
    ;heatup of extruder
    M109 S235
    ; print 150mm priming line
    G1 Y-150 E10.0 F500
    ; Retract
    G10
     
    #3 Lance Weston, Jul 31, 2023

Share This Page