1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved Auto leveling messed up on when doing right side

Discussion in 'Troubleshooting' started by David Head, Jul 17, 2015.

  1. David Head

    David Head New Member

    Joined:
    Jul 17, 2015
    Messages:
    6
    Likes Received:
    1
    I just received my 3D R1 today. No sample print yet. When the ROBO does the 9 point thing it starts at home which is ok, the next check is ok, the front right the hot end raises up from the bed and stays there till it gets back to the left side. Rear middle and left rear are in the raised position...So when it starts to print the head is to far away from the bed surface.... Any ideas...
    Video I took to show what the printer is doing, posted on FB..


    Thanks,
    Dave
     
    #1 David Head, Jul 17, 2015
    Last edited: Jul 17, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    #2 mark tomlinson, Jul 18, 2015
  3. David Head

    David Head New Member

    Joined:
    Jul 17, 2015
    Messages:
    6
    Likes Received:
    1
    Emailed ROBO Tech Support and got an email from Donald. Played with the Z axis level (as been noted on the forum} then deleted the Matter program and reinstalled. I did not update the Matter program using the one that came on the USB stick. Auto Leveling is working great and I am now getting the first layer printing sorted out. Thanks all.

    Dave
     
    #3 David Head, Jul 18, 2015
    Mike Kelly likes this.

Share This Page