Auto Leveling with an inductive sensor

All,

I'm going to enable auto leveling with the inductive sensor following that solution :

http://www.instructables.com/id/Enable-Auto-Leveling-for-your-3D-Printer-Marlin-Fi/

I was wondering is someone as already designed a bracket that hold the sensor for the Robo3D.

If so, can you please publish the file, I haven't found anything on thingiverse.

Thank you

 

are you having issues with mesh leveling? Or do you just want to do something different?

 

I have unmounted the Z axis connector from the beginning as it was not reliable. Since that day for each print I adjust the bed level with the screw. On the top of that my bed is not leveled. So with the inductive sensor I intend to automate this procedure. I have very bad result like elephant feet on one side and very often the print fail because of the bed not perfectly horizontal.

 

have you looked into mesh leveling. would probably solve your problem without making any mechanical modifications