1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Unresolved Autolevel issue?

Discussion in 'Troubleshooting' started by JOAQUIN PICCI, Sep 21, 2015.

  1. JOAQUIN PICCI

    JOAQUIN PICCI Member

    Joined:
    Jul 11, 2015
    Messages:
    110
    Likes Received:
    13
    My problem is this, install the "cooling fan duct" on my "ROBO R1" and I did something wrong and the printer seems to have misconfigured. When you start printing makes self leveling but it does begin printing from a much higher altitude at which it was before. The "z offset" remains as before, but began to print as if "4"
     
    #1 JOAQUIN PICCI, Sep 21, 2015
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Sounds like one or both of the Z switches has been misaligned
     
    #2 mark tomlinson, Sep 21, 2015
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    I agree with mark. Do a paper leveling to align the X axis against the bed
     
    #3 Mike Kelly, Sep 21, 2015
  4. JOAQUIN PICCI

    JOAQUIN PICCI Member

    Joined:
    Jul 11, 2015
    Messages:
    110
    Likes Received:
    13
    Is there a tuto?
     
    #4 JOAQUIN PICCI, Sep 21, 2015
  5. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    #5 Mike Kelly, Sep 21, 2015
  6. JOAQUIN PICCI

    JOAQUIN PICCI Member

    Joined:
    Jul 11, 2015
    Messages:
    110
    Likes Received:
    13
    thanks, ill check it at home :)
     
    #6 JOAQUIN PICCI, Sep 21, 2015

Share This Page