1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Cable Holder

Discussion in 'Mods and Upgrades' started by KTMDirtFace, May 23, 2015.

  1. KTMDirtFace

    KTMDirtFace Well-Known Member

    Joined:
    May 18, 2015
    Messages:
    1,247
    Likes Received:
    461
    The wrapped cables on the right side of my new ROBO3D R1 kept getting caught up in the wiring of the switch under the right side z switch deal.

    Thing: http://www.thingiverse.com/thing:844879

    Whipped this up in Moment of Inspiration and stuck it on with 3M Double sided tape from home depot. The gap is big enough that you can still pull the cables out of it without peeling the tape but it holds it out of the way.

    Cables were getting caught
    [​IMG]

    Fixed
    [​IMG]

    [​IMG]

    [​IMG]

    Moment of Inspiration file is included.
    [​IMG]
     
    #1 KTMDirtFace, May 23, 2015
    Last edited: May 23, 2015
    Mike Kelly likes this.

Share This Page