1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Can you turn off the Robo's Leds?

Discussion in 'General Questions' started by Brandon Young, Nov 13, 2015.

  1. Brandon Young

    Brandon Young New Member

    Joined:
    Jun 25, 2014
    Messages:
    6
    Likes Received:
    0
    Is there a gcode command or something to turn off the leds so I can go to sleep at night?
     
    #1 Brandon Young, Nov 13, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Nope. You'd either need to unplug them or put a switch on that you can use to disable them.
     
    #2 Mike Kelly, Nov 14, 2015
  3. Brandon Young

    Brandon Young New Member

    Joined:
    Jun 25, 2014
    Messages:
    6
    Likes Received:
    0
    Where are the connections on the board
     
    #3 Brandon Young, Nov 14, 2015
  4. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Depends. I'd just follow the wires back from the leds
     
    #4 Mike Kelly, Nov 14, 2015
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,915
    Likes Received:
    7,338
    Yes, or put a small switch in-line with one lead.
     
    #5 mark tomlinson, Dec 22, 2015
    Mike Kelly likes this.
  6. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 11, 2013
    Messages:
    6,967
    Likes Received:
    2,277
    Be sure the power is off if you're doing any cutting...
     
    #6 Mike Kelly, Dec 22, 2015

Share This Page