1. Got a question or need help troubleshooting? Post to the troubleshooting forum or Search the forums!

Solved cannot remove extruder

Discussion in 'Troubleshooting' started by eric tobin, Jul 21, 2017.

Thread Status:
Not open for further replies.
  1. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    there are no screws where there should be. extruder is being held by something but I cant find it, need to remove to unjam fillament
     
    #1 eric tobin, Jul 21, 2017
  2. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    which printer.
    Details matter
    beta-R1 have screws on the side, R1+ has them underneath with a quick-release slide-plate.
     
    #2 mark tomlinson, Jul 21, 2017
  3. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    #3 mark tomlinson, Jul 21, 2017
  4. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    well I see one screw from the bottom, towards the front, no other screws
     
    #4 eric tobin, Jul 21, 2017
  5. mark tomlinson

    mark tomlinson ༼ つ ◕_ ◕ ༽つ
    Staff Member

    Joined:
    Feb 21, 2013
    Messages:
    23,917
    Likes Received:
    7,338
    read the thread I linked.

    Loosen the screw and the quick-release plate will slide out* (assuming an R1+ -- you still have not said which printer)




    *not on its own, you will need to slide it out...
     
    #5 mark tomlinson, Jul 21, 2017
  6. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    thanks for the lick, it was the right screw, just got this, of course a jam, did not want to go messing it up thank you
     
    #6 eric tobin, Jul 21, 2017
  7. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    it was a r1 +plus sorry
     
    #7 eric tobin, Jul 21, 2017
  8. eric tobin

    eric tobin Member

    Joined:
    Jul 15, 2017
    Messages:
    76
    Likes Received:
    16
    uhh, I ment link my bad, but I did the trick thank you very much
     
    #8 eric tobin, Jul 21, 2017
    mark tomlinson likes this.
Thread Status:
Not open for further replies.

Share This Page